Paxton Net2 Caller ID reader Uživatelský manuál stáhnout pdf

LED indications

Power - 12v DC supply OK

Network - Connected to the Mobile phone network

Activity - The reader is receiving data from a mobile phone

Ins-30150 Net2 Caller ID reader

15/04/2011

Technical Support

Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT)

Saturday from 09:00 - 13:00 (GMT)

01273 811011

[email protected]

Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/

Paxton

Installation

Insert the SIM card in its holder at the top right of the unit.

A drilling template for the plastic housing is available at < http://paxton.info/1715 >

If the device is to be installed where the mobile signal may be low, the antenna should be installed externally.

Secure the antenna by:

1. Internal - Remove the peel off paper from the adhesive strip and x within the enclosure.

2. Externally - Disconnect the SMA screw connection and route the cable through any of the cabinet push-out plugs

and x to a smooth surface.

Wire the Caller ID reader colour for colour to a Net2 ACU reader port within a maximum cable length of 15 metres.

Belden 9540 is recommended for all data cable wiring.

If a token reader is also tted, it is connected to the Caller ID's own reader port within a maximum cable length to

the Net2 ACU of 100 metres.

Power up the unit and conrm that the Power LED comes on. The Network LED will come on within a few minutes

once the unit is active on its GSM network.

To register the SIM, create an account on the Paxton website. < http://paxton.info/1713 >

The phone number will be supplied within 60 minutes of this process. There is a small monthly charge per SIM for

this service, however, no data charges are incurred as the caller ID is sent without making a full connection.

Connection to a Net2

ACU reader port

Power

redaeR

Control Unit

SIM CARD

Network

Activity

Net2

Caller ID reader

(Optional)

Antenna

1 2 3 4

01273 811011 1
Specications 2

Shrnutí obsahu

Strany 1 - 01273 811011

LED indications Power - 12v DC supply OKNetwork - Connected to the Mobile phone networkActivity - The reader is receiving data from a mobile

Strany 2 - Specications

10V DC 14V DC500 mA15 m- 20 °C + 55 °C200 mm 200 mm 75 mmSpecications Operating temperatureElectrical Environment Dimensions Min Max Width Height Dep

Strany 3

Ins-30150 Net2 Caller ID reader Technical SupportTechnical help is available: Monday - Friday from 07:00 - 19:00 (GMT)

Strany 4

Set the reader operating mode in the Net2 software to 'Paxton Reader' and the Operating mode to 'Token only'Enter the last 8 digit

Komentáře k této Příručce

Žádné komentáře

Paxton Net2 Caller ID reader Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Pro domov Paxton Net2 Caller ID reader. Paxton Net2 Caller ID reader User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Pro domov Paxton Net2 Caller ID reader